Merchandise Description
Product Title: Forklift computerized transmission hydraulic torque converter
Solution Model: CZPT ulic torque converter BSX-YJH3.fifteen-H-8-TL
| Item | Description |
| Product Title | Hydraulic torque converter |
| P/N | BSX-YJH3.fifteen-H-8-TL |
| Applied Product | For CZPT forklift truck 5-10T, 6110 (CA6110/TL)-one |
| Net CZPT ght (kg) | 28 |
| Gross CZPT ght (kg) | 35 |
| Qty for every Carton | one |
| Carton Size (cm) | 45*45*35 |
Forklift CZPT ulic Torque Converter
Forklift hydraulic torque converter is composed of four simple elements: pump wheel, turbine, and guide wheel, and torque converter housing.
Principal Areas of Forklift CZPT ulic Torque Converter are As Follows:
1. Pump wheel of forklift hydraulic torque converter
Forklift torque converter pump wheel is the energetic part of the torque converter. It is welded with the torque converter shell. The torque converter shell assembly is set to the rear flange of the engine crankshaft with bolts. Inside the pump wheel there are a sequence of blades to give the functioning fluid an additional acceleration and added vitality. A information ring is offered within the blade to enable the transmission oil to flow efficiently.
2. Turbine wheel of forklift hydraulic torque converter
Forklift torque converter turbine wheel is the pushed component of the torque converter. It is connected to the input shaft of the planetary equipment transmission by way of a spline. It absorbs kinetic power from the shifting liquid and converts the kinetic vitality into rotational kinetic power. Like the pump wheel, the turbine is also geared up with several blades.
three. Xihu (West CZPT ) Dis. wheel of forklift hydraulic torque converter
Forklift torque converter information wheel is situated among the pump wheel and the turbine, and is the reaction aspect of the hydraulic torque converter. It is mounted on the information wheel bushing (connected to the transmission housing) via a 1-way clutch. It is utilized to handle the backflow of liquid from the center of the turbine again to the middle of the pump wheel, that is, to change the direction of the liquid movement that leaves the turbine and returns to the pump wheel.
Install 1.1. Cleanse all oil, dust and paint from shafts, bushing holes, bushing exterior and holes of components (sprockets, pulleys, etc.). Insert the bushing into the assembly. 3. Match the pattern of holes, not threaded holes (every single hole is threaded on 1 side only). Insert the socket head cap screws or screws into the 50 %-threaded holes shown in the image beneath. Set up the assembly on the shaft. 4. Transform the torque setting or go over screw* to the recommended torque environment in the diagram beneath. Fill any unfilled holes with grease.